New Parts Topic

I found something else today I had that I left out of the old store. It's the Wheel Horse #112185 connector housing. Toro no longer has the 105312 connector terminals for it but we do. This is the female connector housing that fits the connection to the Magnum engines on the harness side, the engine side of the connector is the same parts that are used in our Indak switch pigtail.

I'm not gonna put it in the old store but it is in the new one.

It is here - 112185 Female Indak Housing

Just added 3 more new pieces to the new store. We've been making them for many years but up until now were just available to walk in customers. They will be available as soon as the new store is done.

Made a few new things yesterday.

#1 - the smaller battery clamp for the round hoods and short frame tractors #4958.
#2 - the rear slot hitch stay.

The stay took a little while but I had to make a jig to bend them and they need a lot of clean up after they are done.

Of course there is a tractor here that needs them along with the last Kohler plug wire I haven't done yet, that's why things get done sometimes lol... :rolling

The longer Onan 0167-1615-04 front plug wire is in the old store. Had some calls for them and found out that the Onan plug wires for the P216, 218 and 220 are unavailable nationwide with no ETA on when they will be available. This one is made just like the smaller one (0167-1615-01) that we make only longer.

They are here at the Stables though.

Edit: They are in both stores now.

All the plug wires made so far are here - Plug Wires

The Kohler plug wires for the front lower coil mount like the 753, 854, etc are done too. Just need to get them in the store today. :smile2

I didn't get more plug wires for the Kohler above made but I did get the shorter (short frame) 4958 battery clamp in the new store this morning. Not a lot of difference but enough to warrant another part.

They are here - 4958 Battery Clamp

I thought I put this one in here but missed it. The rear long hitch holder pin is in the store now too. It comes with spacers and clips as well.

Too many things going on at once.

It is here - Rear Hitch Mounting Pin Assy

The plug wires for the lower front mounted coils are made up and in the store. Didn't make a lot of them because it wasn't used on too many years.

They are here - 238057-12 Plug Wire

I guess the only Kohler wire left to make is take a 4HP apart and make something for it.

The slot hitch stays are now in the store.

They are here - Slot Hitch Stay

I've been forgetting to add links to the store for all of the new stuff here lately. I just edited a lot of posts above and added links. I got too excited and need to slow down I guess.